Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
- 10. Brake system
   10.1. Introduction
   10.2. Technical characteristics
   10.3. Replacement of brake shoes on disk brakes
   10.4. Support of disk brakes
   10.5. Brake disk
   10.6. Replacement of brake shoes of drum brakes
   10.7. Working brake cylinder
   10.8. Main brake cylinder
   10.9. Brake pipelines and hoses
   10:10. Replacement of the regulator of pressure
   10:11. Pumping of the hydraulic brake system
   10:12. Adjustment of the emergency brake
   10:13. Replacement of a cable of the emergency brake
   10:14. Replacement of brake shoes of the emergency brake on back disk brakes
   10:15. Additional brake system
   10:16. Vacuum amplifier of brakes
   10:17. Stoplight switch
   10:18. Anti-blocking system of brakes (ABS)
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment






10:12. Adjustment of the emergency brake

GENERAL INFORMATION

If when tightening the lever of the emergency brake against the stop it passes a way, the corresponding from 5 to 8 clicks, adjustment of the emergency brake means it is executed correctly. If the course makes less than five clicks, then brake shoes will be partially pressed to a brake disk. If course more than 8 clicks, then efficiency of a zatormozhivaniye emergency brake insufficient.

PERFORMANCE ORDER
1. For access to the regulator of a cable of the emergency brake remove the central console.
2. Weaken a lock-nut (the top nut) and adjust the provision of an adjusting nut so that when tightening the lever of the emergency brake its course made 5–8 clicks.
3. After adjustment of the emergency brake tighten a lock-nut.
4. Install the central console.