Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
- 10. Brake system
   10.1. Introduction
   10.2. Technical characteristics
   10.3. Replacement of brake shoes on disk brakes
   10.4. Support of disk brakes
   10.5. Brake disk
   10.6. Replacement of brake shoes of drum brakes
   10.7. Working brake cylinder
   10.8. Main brake cylinder
   10.9. Brake pipelines and hoses
   10:10. Replacement of the regulator of pressure
   10:11. Pumping of the hydraulic brake system
   10:12. Adjustment of the emergency brake
   10:13. Replacement of a cable of the emergency brake
   10:14. Replacement of brake shoes of the emergency brake on back disk brakes
   10:15. Additional brake system
   10:16. Vacuum amplifier of brakes
   10:17. Stoplight switch
   10:18. Anti-blocking system of brakes (ABS)
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment






10.9. Brake pipelines and hoses

GENERAL INFORMATION

Brake tubes and hoses are applied to transfer of brake fluid from the main brake cylinder to working brake cylinders. Connections of tubes both brake cylinders and distributing devices it is made by conical couplings. The ends of tubes are pressed out and have the cone-shaped form for the corresponding size of conical carving openings in brake cylinders or distributing devices.

Before sinking of the ends of tubes the lock nut which after a vvinchivaniye of a cone-shaped surface in the conical basis of a carving opening presses and pressurizes a tube is put on them.

Brake hoses carry out mobile communications between mobile and motionless parts of the car.

PERFORMANCE ORDER
1. When unscrewing brake hoses it is necessary to use a cap wrench.
2. Before removal of a brake hose from the supporting arm, remove an U-shaped bracket.
3. Remove a brake hose from the supporting arm.
4. For reduction of losses of brake fluid at removal of working brake cylinders use clips for a perezhatiya of brake hoses.