Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
- 11. Suspension bracket
   11.1. Introduction
   11.2. Technical characteristics
   - 11.3. The lobby is resistant
      11.3.1. Repair of a forward rack
      11.3.2. Forward stabilizer of cross stability
      11.3.3. Lower lever of a forward suspension bracket
      11.3.4. Replacement of the lower hinge of a forward suspension bracket
      11.3.5. Rotary fist
   + 11.4. Rack of a back suspension bracket
   11.5. The air self-leveled suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment






11.3. The lobby is resistant

Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and record on supports. Remove the corresponding forward wheel.
2. Disconnect a brake hose from an arm on a forward rack and a support. Close a brake hose a stopper.
3. If the car is equipped with anti-blocking system, disconnect the electric socket from the ABS sensor.
4. Apply a tag on the top bolt of fastening of a forward rack to a rotary fist.
5. Note the provision of a rack on a rotary fist.
6. Unscrew two bolts of fastening (the right arrow) of a rotary fist to the lower part of a forward rack (the left arrow – a bolt of fastening of a wire of the ABS sensor).
7. Take the top part of a rotary fist from a rack and establish a rotary fist on a support.

Prevention

If the new forward rack is established, combine a tag on a ledge of a rack and a tag on a fastening bolt to keep a wheel disorder corner.


8. Holding a rack from falling, unscrew three nuts of the top fastening of a forward rack.
9. Lower a rack and take from under a forward wing.

Installation

PERFORMANCE ORDER
1. Establish a rack into place and by hand screw three nuts of the top fastening of a forward rack.
2. Insert the top part of a rotary fist into a forward rack and fix by bolts.
3. Install the ABS sensor.
4. Fix a brake hose on a forward rack and screw it on a support. Remove air from the brake system.
5. Establish a wheel and lower the car.
6. Tighten three nuts of fastening of the top part of a forward rack.
7. Check, and if necessary, adjust the angles of installation of forward wheels.