Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
- 12. Steering
   12.1. Introduction
   12.2. Technical characteristics
   12.3. Steering wheel
   12.4. Tips of steering draft
   12.5. Replacement of protective covers of steering transfer
   12.6. Steering transfer
   12.7. Pump of the amplifier of steering
   12.8. Removal of air from system of steering with the amplifier
+ 13. Body
+ 14. Electric equipment






12.4. Tips of steering draft

Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and record on supports. Remove a forward wheel.
2. Record steering draft and unscrew a lock-nut of steering draft on a quarter of a turn. Do not move a lock-nut from this situation as it will serve as a reference point at installation of a new tip of steering draft.
3. At full unscrewing of a lock-nut, using paint, note the provision of a steering rod end on a carving of steering draft.
4. Take the forelock and unscrew a nut of fastening of the spherical hinge of a tip of steering thirst for a rotary fist.
5. Using a stripper, take the spherical hinge of a tip of steering draft from a rotary fist.
6. Unscrew a tip of steering draft from steering draft, having counted the exact speed of a tip of steering draft.
7. Check a condition of a protective cover of the spherical hinge of a tip of steering draft.
8. For replacement of a protective cover of the hinge remove a spring ring.
9. Then remove a protective cover on a pin of the spherical hinge.
10. Wipe the hinge with pure rags, apply on it a lubricant layer, establish a new cover and fix it by a ring.

Installation

PERFORMANCE ORDER
1. Screw a tip of steering draft on steering draft on the same speed, as at removal. At the same time the lock-nut of a tip of steering draft has to be established on a quarter of a turn of steering draft.
2. Install the spherical hinge of a tip of steering draft in a rotary fist and fix by a nut.
3. Tighten a lock-nut of fastening of a tip of steering draft.
4. Establish a wheel and lower the car.
5. Check and, if necessary, adjust the angles of installation of forward wheels.