Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
- 13. Body
   13.1. Introduction
   13.2. Care of a body
   13.3 Care of an upholstery and rugs
   13.4. Repair of insignificant damages of a body
   13.5. Repair of strong damages of a body
   13.6. Cowl
   13.7. Replacement of the lock of a cowl
   13.8. Replacement of a cable of the lock of a cowl
   13.9. Front grille
   13:10. Front bumper
   13:11. Rear bumper
   13:12. Forward wing
   13:13. Door upholstery
   13:14. Lock, cylinder of the lock and handle of opening of a door
   13:15. Door glass
   13:16. Window regulator
   13:17. External mirror
   13:18. Doors
   13:19. Trunk lid
   13:20. Luggage carrier lock
   13:21. Cable of opening of the lock of a luggage carrier
   13:22. Replacement of racks of support of a back door
   13:23. Back door
   13:24. Lock of a back door, external handle and cylinder of the lock
   13:25. Casings of a steering column
   13:26. Central console
   13:27. Dashboard elements
   13:28. Dashboard
   13:29. Air inlet lattice
   13:30. Front seats
+ 14. Electric equipment






13:28. Dashboard

GENERAL INFORMATION

Arrangement of bolts of fastening of the dashboard and electric sockets

1 – the gray socket with 15 contacts
2 – the brown socket with 22 contacts
3 – the white socket with 22 contacts
4 – the blue socket with 20 contacts
5 – the black socket with 22 contacts
6 – the blue socket with 4 contacts
7 – the black socket with 1 contact
8 – the black socket with 1 contact

PERFORMANCE ORDER
Models from 1990 to 1994
1. Remove a weight wire from the accumulator.
2. Remove a steering wheel.
3. Remove the central console.
4. Remove the decorative caps closing screws of fastening of the dashboard.
5. Remove the lower finishing of the dashboard. Unscrew the lever of opening of a cowl and remove it together with a cable.
6. Remove a decorative overlay of a combination of devices.
7. Remove a combination of devices and disconnect a speedometer drive cable.
8. Remove a ware box and disconnect the electric socket from the heater fan engine.
9. Unscrew 4 screws of fastening of the holder of the central part of finishing of the dashboard and remove it.
10. Disconnect a cable of management of a heater from a heater.
11. Remove the radio receiver.
12. Unscrew bolts which fix a steering column to the dashboard, and lower a steering column.
13. Unscrew the bolts fixing the dashboard to a partition of a motor compartment, disconnect electric sockets from the dashboard and take the dashboard from interior of the car.
14. Installation is made in the sequence, the return to removal.
Models since 1995
15, Remove the central console.
16. Remove finishing of the lower part of the dashboard.
17. Remove a ware box.
18. Unscrew screws and remove the back panel of a ware box.
19. Unscrew bolts of fastening of a steering column and lower a steering column down.
20. Move the lever of adjustment of temperature to situation "MAX COLD", then disconnect a cable of management of temperature from a heater.
21. Remove decorative caps and unscrew the bolts of fastening of end faces of the dashboard which opened under them.
22. On models with the airbag of safety disconnect on the right side under the dashboard yellow electric sockets.
23. Disconnect electric sockets and unscrew bolts of fastening of the dashboard.
24. Remove a lattice of a heater and unscrew the opened two bolts.
25. Remove the dashboard.
26. Installation is made in the sequence, the return to removal.