Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
- 14. Electric equipment
   - 14.1. Body electric equipment
      14.1.1. Introduction
      14.1.2. Electric chains
      14.1.3. Detection of not closed chain
      14.1.4. Safety locks
      14.1.5. Chain breakers
      14.1.6. Relay
      14.1.7. Relay of turns and alarm light system
      14.1.8. Multipurpose switches of a steering column
      14.1.9. Ignition lock
      + 14.1.10. Replacement of switches of the dashboard
      14.1.11. Combination of devices
      14.1.12. Radio receiver
      14.1.13. Loudspeakers
      14.1.14. Antenna
      14.1.15. The antenna with the electric drive
      14.1.16. Replacement of bulbs of headlights
      14.1.17. Adjustment of light of headlights
      14.1.18. Headlight
      14.1.19. Replacement of bulbs of an incandescence
      14.1.20. Screen wiper engine
      14.1.21. Sound signal
      14.1.22. Check of a heater of back glass
      14.1.23. Window regulators with the electric drive
      14.1.24. Rear-view mirrors with the electric drive
      14.1.25. Safety airbag
   + 14.2. Electrical circuitries






14.1.11. Combination of devices

GENERAL INFORMATION

Arrangement of screws of fastening of a combination of devices on models from 1990 to 1994


Arrangement of screws of fastening of a combination of devices on models since 1995


PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Remove a decorative overlay of a combination of devices.
3. Unscrew screws of fastening of a combination of devices and move a combination of devices to a steering wheel.
4. Disconnect electric sockets and a cable of the drive of a speedometer from a back part of a combination of devices and remove a combination of devices.
5. Installation is made in the sequence, the return to removal.