Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
- 14. Electric equipment
   - 14.1. Body electric equipment
      14.1.1. Introduction
      14.1.2. Electric chains
      14.1.3. Detection of not closed chain
      14.1.4. Safety locks
      14.1.5. Chain breakers
      14.1.6. Relay
      14.1.7. Relay of turns and alarm light system
      14.1.8. Multipurpose switches of a steering column
      14.1.9. Ignition lock
      + 14.1.10. Replacement of switches of the dashboard
      14.1.11. Combination of devices
      14.1.12. Radio receiver
      14.1.13. Loudspeakers
      14.1.14. Antenna
      14.1.15. The antenna with the electric drive
      14.1.16. Replacement of bulbs of headlights
      14.1.17. Adjustment of light of headlights
      14.1.18. Headlight
      14.1.19. Replacement of bulbs of an incandescence
      14.1.20. Screen wiper engine
      14.1.21. Sound signal
      14.1.22. Check of a heater of back glass
      14.1.23. Window regulators with the electric drive
      14.1.24. Rear-view mirrors with the electric drive
      14.1.25. Safety airbag
   + 14.2. Electrical circuitries






14.1.16. Replacement of bulbs of headlights

GENERAL INFORMATION

Prevention

Before replacement of a bulb of external lighting check the corresponding electric chain and a safety lock. Do not concern a glass flask of a lamp barehanded. The fingerprint evaporates and besieged on a reflector therefore lighting worsens. Surely replace the failed lamps with lamps of the same type. Wipe the spots arising on imprudence from touches with a pure lint-free rag or alcohol.


PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Release a clamp and disconnect from the holder of a bulb of a headlight.
3. Remove a rubber protective cover, squeeze a spring clamp and take the holder of a bulb from a headlight casing.
4. Establish the holder of a bulb with a new bulb in a headlight and record a spring clamp.
5. Establish a rubber protective cover, and inscription TORAHS has to be above.
6. Connect the electric socket to the holder of a bulb of a headlight.
7. Check and, if necessary, adjust light of headlights.