+ 1.1. Identification numbers
+ 2. Maintenance
- 3. Engines
3.1. Technical characteristics
3.2. Operations on repair of the engine installed in the car
3.3. Top dead point of the first cylinder
3.4. Cover of a head of the block of cylinders
3.5. Inlet collector
+ 3.6. Gear belt and pulleys
3.7. Replacement of a forward sealing ring of a bent shaft
3.8. Replacement of sealing rings of camshafts
3.9. Camshafts and pushers
3.10. Heads of the block of cylinders
3.11. Oil pallet
3.12. Oil pump
3.13. Drive flywheel / plate
3.14. Replacement of a back sealing ring of a bent shaft
3.15. Suspension bracket of the power unit
+ 3.16. Capital repairs of the engine
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment
Arrangement of a nut of fastening of the right support of the engine
Arrangement of a nut of fastening of the left support of the engine
| PERFORMANCE ORDER
|1. For improvement of access to a suspension bracket of the power unit lift a forward part of the car and record on supports.
|2. Check a condition of rubber elements of a suspension bracket for existence of cracks, aging and stratification.
|3. Check reliability of fastening of engine mounts.
| 4. Moving the engine here and there, check a side play in engine mounts. New elements of a suspension bracket have to have an insignificant side play even.
| PERFORMANCE ORDER
|1. Remove a weight wire from the accumulator. Using the load-lifting mechanism, support the engine.
|2. Unscrew nuts of fastening of a support of the engine to a beam (see rice. Arrangement of a nut of fastening of the right support of the engine, Arrangement of a nut of fastening of the left support of the engine).
|3. Using the load-lifting mechanism, slightly raise the engine.
| 4. Unscrew two bolts fixing an engine support to the block of cylinders and remove an engine support.
|5. Establish the support located between the engine and a beam and fix by bolts.
|6. Slowly lower the engine, at the same time two lower racks have to pass in the corresponding opening in a beam. Tighten bolts of fastening of support of the engine to a beam.