Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
- 3. Engines
   3.1. Technical characteristics
   3.2. Operations on repair of the engine installed in the car
   3.3. Top dead point of the first cylinder
   3.4. Cover of a head of the block of cylinders
   3.5. Inlet collector
   + 3.6. Gear belt and pulleys
   3.7. Replacement of a forward sealing ring of a bent shaft
   3.8. Replacement of sealing rings of camshafts
   3.9. Camshafts and pushers
   3.10. Heads of the block of cylinders
   3.11. Oil pallet
   3.12. Oil pump
   3.13. Drive flywheel / plate
   3.14. Replacement of a back sealing ring of a bent shaft
   3.15. Suspension bracket of the power unit
   + 3.16. Capital repairs of the engine
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment






3.7. Replacement of a forward sealing ring of a bent shaft

PERFORMANCE ORDER
1. Take off a gear belt and a pulley of a bent shaft.
2. Using the screw-driver which edge is wound by an adhesive tape, take a sealing ring of a bent shaft from a nest. At the same time do not damage a nest of a sealing ring and a bent shaft. For simplification of removal of a sealing ring it is possible to cut out an opening in a face surface of a sealing ring.
3. Clear a nest of a sealing ring and oil a new sealing ring pure engine.
4. Using a tubular mandrel of the corresponding diameter, establish a sealing ring on a bent shaft.
5. Establish a pulley of a bent shaft and a gear belt.