Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
- 7. Systems of start, ignition
   7.1. Introduction
   7.2. Technical characteristics
   7.3. Check of the accumulator
   7.4. Accumulator charging
   7.5. Accumulator
   + 7.6. System of ignition
   + 7.7. System of charging
   + 7.8. System of start of the engine
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment






7.4. Accumulator charging

GENERAL INFORMATION

Accumulator charging has to be made when the accumulator is removed from the car.

You make accumulator charging charging current from 3.5 to 4 amperes and until electrolyte density in the accumulator does not increase within 4 hours.

Use of big currents for bystry accumulator charging is not recommended since in this case there can be a buckling of plates because of an overheat.

During accumulator charging temperature of electrolyte should not exceed 37.8 °C.