Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru Legacy
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
- 9. Coupling, shaft
   9.1. Technical characteristics
   + 9.2. Coupling
   - 9.3. Driveshaft
      9.3.1. Removal and installation of the driveshaft
      9.3.2. Replacement of the central bearing of the driveshaft
      9.3.3. Replacement of a sealing ring of the main transfer
   + 9.4. Power shafts
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment






9.3. Driveshaft

GENERAL INFORMATION

Driveshaft

 
1 – forward part of the driveshaft
2 – central bearing
3 – back part of the driveshaft
4 – flange
5 – washer

The driveshaft connects the transmission to reverse main gear.

Forward shlitsevy part of the driveshaft is established in a back part of the transmission and is condensed with a sealing ring. Shlitsevy connection of the driveshaft with the transmission provides necessary axial movement of the driveshaft at the movement of the car.

Back part of the driveshaft fastens bolts to a flange of the main transfer.

As the driveshaft is the balanced knot, sticking of dirt to it is inadmissible. At a car raising for maintenance it is expedient to clear the driveshaft and to check it for damages. Every time when the driveshaft is removed, for prevention of balancing it should be established in the same situation.

Problems with the driveshaft are usually shown in the form of noise or vibration at the movement of the car. Check in the movement reveals driveshaft problems.